contractors homeowners

Retaining Walls with Geogrid    View Complete Residential Retaining Wall Manual

What is Geogrid?

Geogrids are flexible, synthetic meshes which are manufactured specifically for slope stabilization and earth retention. These “grids” are available in a variety of materials, sizes and strengths. They can be made of high tensile strength plastics or woven polyester yarns and are typically packaged at the factory in rolls.

See the importance of reinforcement in your retaining wall with this sand castle demonstration.

Use the Soil Reinforcement Chart to determine the size of AB Grid you will need and how many layers your retaining wall requires.

How Grid Works

The sand castle test takes two cylinders of soil and applies vertical force to see how the soil performs. The first cylinder is just compacted material. The second is also compacted material with the addition of mesh screens to simulate the use of geogrid reinforcement. Learn more about how grid works...

Install Reinforcement

Install AB Reinforcement Grid

Install AB Reinforcement Grid

Install the next course

Install the next course of blocks

Backfill over grid and compact

Backfill over grid and compact

Install next course of blocks and geogrid

Install next course of blocks and geogrid

  • Once the base course is complete, begin installing the first layer of AB Reinforcement Grid. When using AB Collection, begin by placing the edge of the geogrid against the back of the raised front lip and rolling it out along the retaining wall. Always refer to your approved plans for exact size and location.
Never compact on grid

Never compact directly on top of grid

  • Stack the next course of blocks so that the vertical seams are offset from the blocks below by at least 1/4 the length of the block.
  • Sight down the retaining wall line to check for alignment. Blocks may be adjusted slightly to form straight lines or smooth flowing curves.
  • Pull on the back of the geogrid to remove any slack. If necessary, stake it in place. Never drive or compact directly on the geogrid. This will cause damage to the geogrid.

Backfilling and Compaction

  • Install wall rock in the block cores and 300 mm behind the block. Use infill or approved on-site soils to backfill behind the wall rock to the height of the block.
  • The wall rock and infill soils behind the retaining wall must be properly compacted using a plate compactor. Compact in lifts of 8 in. (200 mm) or less, this time starting on the block and working in a path that runs parallel to the block and towards the back of the excavated area. Always make a minimum of two passes with a plate compactor. Compaction should be continued to achieve solid, movement-free soil.
  • Remove all excess material from the top surface of all blocks. This prepares a clean, smooth surface for placement of the next course.

Additional Courses

How to build a reinforced retaining wall

Build a reinforced retaining wall

  • Continue installing your next courses of block using the steps shown above. Per your approved plans,install geogrid on every other course of the retaining wall.
  • Using these steps complete the retaining wall to the desired height. On the last course, fill behind the blocks with organic soils in place of infill or approved on-site soils. This will assist in any plantings above the retaining wall and also to direct water from running behind the blocks. More information on finishing your retaining wall.